SE-4220 Manuals


SE-4220 Manual Battery Charger
Battery
2 Amp, 12V; 10 Amp, 12V
Charger 40 Amp, 6 & 12V
Owner's Manual
Model:
200 Amp, 12V, Engine Start
100 Amp, 6V, Engine Start

–Save–
Important Safety Instructions
Read Rules for Safe Operation and Instructions Carefully
Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal
battery operation. For this reason, it is of utmost importance that each time before using your charger, you
read this manual and follow the instructions exactly.
WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a
chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
A.
GENERAL BATTERY SAFETY
1.
Before you use your battery charger, be sure to read all
10. Do not use an extension cord unless absolutely necessary.
instructions and cautions printed on:
Use of an improper extension cord could result in fire or
electric shock. If an extension cord must be used, make
• Battery Charger
• Battery
sure that:
• Vehicle or unit using battery
• Pins on plug of extension cord are the same number,
2.
Use battery charger on LEAD ACID type rechargeable
size, and shape as those of the plug on the charger.
• Extension cord is properly wired and in good electrical
batteries only, such as used in autos, trucks, tractors,
condition.
airplanes, vans, RV's, trolling motors, etc. Charger is not
• Wire size is large enough for AC ampere rating of charger,
intended to supply power to low-voltage electrical system
as specified below:
other than in an automotive application.
WARNING: Do not use battery charger for charging dry-
cell batteries that are commonly used with home appliances.
Length of cord (feet):
25
50
100
150
These batteries may burst and cause injury to persons and
AWG size of cord:
16
12
  10
     8
damage to property.
3.
Use only attachments recommended or sold by
(American Wire Gauge)
manufacturer. Use of non-recommended attachments may
result in fire, electric shock, or injury.
11. Always charge battery in a well ventilated area.
4.
When disconnecting the battery charger, pull by the plug
NEVER operate in a closed-in or restricted area without
not by the cord. Pulling on the cord may cause damage to
adequate ventilation because of risk of explosive gases.
cord or plug.
WARNING: Risk of explosive gas.
5.
Locate battery power cord so it cannot be stepped on,
12. Locate charger as far away from battery as DC charger
tripped over, or subjected to damage or stress.
cables permit.
6.
Do not operate charger with damaged cord or plug. Have
13. Do not expose charger to rain or snow.
cord replaced immediately.
14. NEVER charge a frozen battery. If battery fluid (electrolyte)
is frozen, bring into a warm area to thaw before charging.
7.
Do not operate charger if it has received a sharp blow,
15. NEVER allow battery acid to drip on charger when reading
been dropped, or otherwise damaged in any way. Take it to
specific gravity or filling battery.
a qualified professional for inspection and repair.
16. NEVER set a battery on top of charger.
8.
Do not disassemble charger. Take it to a qualified
17. NEVER place charger directly above battery being charged.
professional when service or repair is required. Incorrect
Gases from battery will corrode and damage charger.
reassembly may result in electric shock or fire.
18. NEVER touch the battery clips together when the charger
9.
To reduce risk of electric shock, unplug charger from outlet
is energized.
before attempting any maintenance or cleaning.
SCHUMACHER ELECTRIC CORPORATION
801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, ILLINOIS 60056-2179
Send Warranty Product Repairs to: 1025 E. Thompson, Hoopeston, IL 60942-0280
Call Customer Service if you have questions: 1-800-621-5485
00-99-000-414/0204
1


Big size of image:

Please install Flash player from http://get.adobe.com/flashplayer/!

37 37 51 51

Designated trademarks and brands are the property of their respective owners | Disclaimer