IS:404SK Manuals
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING LUMINAIRE
INSTRUCTION SHEET NO.
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
IS:404SK
Retain these instructions for maintenance reference.
A0204
Page 1
SUPPLY
INSTRUCTION SHEET FOR ASSEMBLY AND INSTALLATION OF
1/4-20 SCREW
LEADS
9”,12”&16” PENDALYTE™ SERIES WITH CORD AND CABLE
CROSSBAR
OUTLET BOX
Note: This instruction sheet covers several luminaire styles.
SCREWS
Powerhead assembly, lamp type, and reflector style may vary slightly
from that shown, although installation is the same.
CANOPY INSTALLATION (fig. 1):
1.
Thread 1/4-20 SCREW through CROSSBAR as shown.
CANOPY
2.
Using appropriate slots in CROSSBAR, secure CROSSBAR to
outlet box using OUTLET BOX SCREWS (provided with outlet
box).
3.
Make electrical connections: black POWERCORD lead to hot
RELIEF BUSHING
(black) supply lead; white POWERCORD lead to neutral (white)
supply lead. Green POWERCORD lead is ground wire and must
be connected to grounding terminal or ground lead inside outlet
box. Use WIRE NUTS (local hardware item). Push supply leads
into outlet box. Note: Refer to POWERHEAD instruction sheet
CABLE COUPLER
for detailed wiring information.
4.
Secure POWERCORD into CANOPY with RELIEF BUSHING.
5.
Slide CABLE through CABLE COUPLER as shown.
6.
Attach CANOPY by placing over 1/4-20 SCREW and securing
with CABLE COUPLER.
CABLE
POWERCORD
CAUTION: MAKE CERTAIN WIRES ARE NOT PINCHED
Fig. 1
BETWEEN PARTS.
POWERHEAD INSTALLATION (fig. 2):
1.
Attach CABLE ADJUSTER to MOUNT PLATE with PANEL NUT.
Note: On 9” unit MOUNT PLATE must be oriented correctly
PLUNGER
to clear DOOR SCREW head (see fig. 2).
2.
Pass POWERCORD through relief bushing hole in MOUNT
CABLE ADJUSTER
PLATE.
3.
While supporting POWERHEAD ASSEMBLY wire luminaire using
RELIEF BUSHING
WIRE NUTS (local hardware item): black luminaire lead to hot
8-32 SCREWS
(black) POWERCORD lead, white luminaire lead to neutral
MOUNT PLATE
(white) POWERCORD lead. Attach luminaire ground wire(s)
(green and/or bare) to green ground wire from POWERCORD.
4.
Height adjustment: to raise luminaire push excess POWERCORD
down into POWERHEAD. (Make certain CABLE does not
PANEL NUT
WIRE NUTS
interfere with internal wiring or components, both POWERCORD
and CABLE may be cut inside POWERHEAD. Remove DOOR
SCREW and pull DOOR away from POWERHEAD). CABLE is
DOOR
inserted into CABLE ADJUSTER. Raise luminaire by providing
SCREW
slack in CABLE and pushing through CABLE ADJUSTER. Lower
POWERHEAD
luminaire by depressing PLUNGER .
ASSEMBLY
DOOR
5.
Secure POWERCORD to MOUNT PLATE with STRAIN RELIEF.
6.
Attach MOUNT PLATE to POWERHEAD with 8-32 SCREWS.
CAUTION: MAXIMUM WATTAGE AS MARKED ON
LUMINAIRE MUST NOT BE EXCEEDED.
Fig. 2
A
COMPANY
631 Airport Road, Fall River, MA 02720
Big size of image:
Please install Flash player from http://get.adobe.com/flashplayer/!