Home Theater Surge Suppressors Manuals


200505036 93-2243 Protect It! OM.qxd  5/23/2005  12:05 PM  Page 1
hance 
TION:
ARRANTY 
or a c
y f
oduct—   
W
Home Theater 
REGISTRATripp Lite pr
.com/warranty
register online toda
Owner’s Manual
.tripplite
Surge Suppressors
to win a FREE 
www
1111 W. 35th Street Chicago, IL 60609 • Customer Support: (773) 869-1234 • www.tripplite.com 
IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension cords or adapters. This surge suppressor
is designed for indoor use only. Install the surge suppressor away from heat-emitting appliances such as radiators or heat registers.
Do not install where excessive moisture is present. Do not plug extension cords into it. Never install electrical, telephone, network
or coaxial wiring during a lightning storm. Do not drill into any part of the housing or open the housing for any reason. There are
no user-serviceable parts inside.
Select models feature an internal protection that 
Connect Your Equipment to the Surge Suppressor’s Coaxial Jacks
will disconnect the surge-protective component at the 
(Optional Installation): Connect a coaxial cable from the wall jack directly to
end of its useful life but will maintain power to the load—
the surge suppressor’s “F” style coaxial jack labeled “IN.” Connect a coaxial
now unprotected.
cable from the surge suppressor’s “F” style coaxial jack labeled “OUT” directly to
the device to be connected. Select models include a second set of coaxial jacks
for simultaneous connection and protection of devices on two separate lines (cable,
Installation
antenna or satellite). The surge suppressor must always be the first item con-
nected in line from the coaxial wall jack. The surge suppressor must be plugged into
Mount Your Surge Suppressor (Optional Installation): If desired, mount
a 3-wire grounded AC outlet for coaxial line surge protection to work. Make
your surge suppressor on a wall or other sturdy, vertical surface. However, you
sure coax cables connected to satellite dishes, antennas, etc. are also grounded.
must mount the surge suppressor prior to connecting your equipment. Place a
sheet of paper over the surge suppressor’s mounting holes and mark their cen-
ters with a push pin. Next, place this template over the desired area and mark
FCC Part 68 Notice (United States Only)
with the push pins. Install screws (user supplied) into the marks until ¼ in. (0.5
If your Modem/Fax Protection causes harm to the telephone network, the telephone company may temporarily discontinue your
service. If possible, they will notify you in advance. If advance notice isn’t practical, you will be notified as soon as possible. You
cm.) of the screw heads are exposed. Mount the surge suppressor over the
will be advised of your right to file a complaint with the FCC. Your telephone company may make changes in its facilities, equipment,
screw heads and slide into place.
operations or procedures that could affect the proper operation of your equipment. If it does, you will be given advance notice to
give you an opportunity to maintain uninterrupted service. If you experience trouble with this equipment’s Modem/Fax Protection,
Connect Your Surge Suppressor to the AC Power Line: Plug the surge 
please contact Technical Support, Tripp Lite; 1111 W. 35th Street, Chicago, IL 60609; Phone: (773) 869-1234, for repair/warranty
information. The telephone company may ask you to disconnect this equipment from the network until the problem has been corrected or
suppressor’s power cord into a standard, 3-wire grounded 120V AC, 60 Hz. outlet.
you are sure the equipment is not malfunctioning. There are no repairs that can be made by the customer to the Modem/Fax
Protection. This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject
Turn Your Surge Suppressor ON: Press the surge suppressor’s power switch
to state tariffs. (Contact your state public utility commission or corporation commission for information.)
down or to “RESET” (depending on model). Select models feature an illumi-
nated switch.
Lifetime Limited Warranty 
Check Your Surge Suppressor’s Diagnostic Indicator Lights: Check the
Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and
workmanship for its lifetime. If the product should prove defective in material or workmanship within that period, Seller will repair or
LEDs prior to connecting your equipment. They will indicate various operating
replace the product, in its sole discretion. Service under this Warranty can only be obtained by your delivering or shipping the product
conditions when the surge suppressor is plugged into a live 120V AC outlet
(with all shipping or delivery charges prepaid) to: Tripp Lite, 1111 W. 35th St., Chicago, IL 60609. Seller will pay return shipping charges.
and the surge suppressor’s power switch is on.
The warranties of all TRIPP LITE surge suppressors are null and void if they have been connected to the output of any UPS system.
The warranties of all TRIPP LITE UPS Systems are null and void if a surge suppressor has been connected to its output receptacles.
“PROTECTED” LED: Indicates the surge suppression components are
THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE
intact and providing complete protection against surges. If this LED does not
OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH
HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WAR-
illuminate, some of the surge suppression components are not functioning,
RANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH
and the unit should be replaced. Call Tripp Lite Customer Support at (773)
ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states
do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental
869-1234.
or consequential damages, so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal
rights, and you may have other rights which vary from jurisdiction to jurisdiction.)
“GROUNDED” LED: Indicates wall outlet is grounded and surge protection
TRIPP LITE; 1111 35th St.; Chicago, IL 60609
can properly function. If this light DOES NOT illuminate and power is pres-
WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the
ent, consult a qualified electrician to examine your outlet’s wiring.
use intended. Since individual applications are subject to great variation, the manufacturer makes no representation or warranty
as to the suitability or fitness of these devices for any specific application.
Connect Your Equipment to the Surge Suppressor’s AC Outlets: Plug
Policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.
your equipment’s power cords (including 2-wire devices) into the surge sup-
Regulatory Compliance Identification Numbers
pressor’s AC outlets. Select models feature integrated safety covers which cover the
For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique
outlets when not in use. Other models feature special widely-spaced outlets to
series number. The series number can be found on the product nameplate label, along with all required approval markings and
accommodate transformers without covering other outlets. DO NOT plug in
information. When requesting compliance information for this product, always refer to the series number. The series number
should not be confused with the marking name or model number of the product.
extension cords. DO NOT OVERLOAD the surge suppressor’s outlets. The
This product designed and engineered in the USA.
surge suppressor can accommodate a total equipment load of up to 15 amps
(whether plugged into a single outlet or spread out over multiple outlets). If
the load on the surge suppressor exceeds 15 amps, the circuit breaker* will trip
Ultimate Lifetime Insurance Policy
and the outlets will stop providing power. If the circuit breaker trips, reduce the
(Valid in the U.S. and Canada Only)
load by unplugging some devices. Depress the circuit breaker or switch to
Tripp Lite warrants, for the lifetime of the product, (at Tripp Lite's option) to repair or replace (on a pro rata basis) directly connected
“RESET” to reset the breakers and restore power.
equipment that is damaged due to power transients while properly connected to Tripp Lite products offering the Ultimate Lifetime
Insurance Policy.  Power transients include spikes and surges on the AC power, data or telephone lines that the Tripp Lite products
* Circuit breakers are integrated into the power switch on select models and offered as a separate
have been designed to protect against (as recognized by industry standards).  
feature on other models.
AC Power Line Transients: To claim damages, the Tripp Lite product must be plugged into a properly wired and grounded outlet. No
extension cords or other electrical connections may be used. The installation must comply with all applicable electrical and safety
Connect Your Equipment to the Surge Suppressor’s Phone Jacks
codes set forth by the National Electrical Code (NEC). Except as provided above, this warranty does not cover any damage to prop-
(Optional Installation. Available on Select Models Only): Connect a phone
erly connected electronic equipment resulting from a cause other than an “AC power transient”. If user meets all of the above require-
ments, Tripp Lite will repair or replace (at Tripp Lite’s option) equipment up to the specified value (See Ultimate Lifetime Insurance
cable from the wall jack directly to the surge suppressor’s RJ-style phone jack
Policy Limits). No coverage is allowed for damage entering from telephone or data lines, unless they are separately protected, as
labeled “IN.” Connect a phone cable from the surge suppressor’s RJ-style phone
described below. 
jack labeled “OUT” directly to the device to be protected. Select models feature
Telephone and Data Line Transients: Tripp Lite will repair or replace directly connected equipment that is damaged by transients on
telephone and/or data lines only when all such paths are protected by a Tripp Lite protection product(s) and the AC power (utility) line
two “OUT” jacks; either one or both of the jacks may be used, but protection
is simultaneously protected by a Tripp Lite power protection device (UPS, surge suppressor or line conditioner) with Ultimate Lifetime
is for a device or devices sharing a single line only. The surge suppressor must
Insurance coverage. Additional telephone and/or data line connected devices downstream must have their own telephone and/or
dataline protectors.
always be the first item connected in line from the wall jack. The surge suppres-
Reimbursement dollar limits will be equal to that of the Tripp Lite power protection protector. Coverage is excluded where a suitable
sor must be plugged into a 3-wire, grounded AC outlet for phone line surge pro-
environment for the protection device is not provided, including, but not limited to, lack of a proper safety ground. Telephone service
tection to work.
equipment must also include a properly installed and operating "primary protection" device at the telephone service entrance (such
devices are normally added during telephone line installation).  
Connect Your Equipment to the Surge Suppressor’s Network Jacks*
All above warranties are null and void if the Tripp Lite product has been improperly installed, tampered with or altered in any way, or
if the connected equipment was not used under normal operating conditions or in accordance with any labels or instructions. All claims
(Optional Installation. Available on Select Models Only): Connect a data
under this warranty must be submitted in writing to Tripp Lite within 30 days of the occurrence or the claim will not be considered.
cord from the wall jack or cable/DSL modem directly to the surge suppressor’s
This warranty does not include damage resulting from accident or misuse, and applies to the domestic (USA & Canada) use of these
network jack labeled “IN.” Connect a data cord from the surge suppressor’s
products only.
Tripp Lite reserves the right to determine whether the damage to the connected equipment is due to malfunction of the Tripp Lite product
network jack labeled “OUT” directly to the device to be protected. The surge
by requesting the equipment in question be sent to Tripp Lite for examination. This policy is above and beyond, only to the extent
suppressor must always be the first item connected in line from the Ethernet
needed, of that provided by any coverage of connected equipment provided by other sources, including, but not limited to, any man-
source (typically a wall jack). The surge suppressor must be plugged into a 
ufacturer’s warranty and/or any extended warranties.
EXCEPT AS PROVIDED ABOVE, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES
3-wire grounded AC outlet for network line surge protection to work.
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of
* 10/100 BaseT/TX, Token Ring. Not compatible with PoE (Power Over Ethernet) applications.
implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL
OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY
OF SUCH DAMAGE. Specifically, Tripp Lite is not liable for any costs, such as lost profits or revenue, loss of equipment, loss of use
of equipment, loss of software, loss of data, costs of substitutes, claims by third parties or otherwise. Coverage also does not apply
to connected medical and industrial equipment.
To receive service under this warranty, you must be the original purchaser/user of the product in question. You must obtain a Returned
Material Authorization (RMA) number from Tripp Lite. Products must be returned to Tripp Lite with transportation charges prepaid and
must be accompanied by a brief description of the problem encountered and proof of date and place of purchase.
Copyright © 2005. All rights reserved.


Big size of image:

Please install Flash player from http://get.adobe.com/flashplayer/!

40 40 46 46

Designated trademarks and brands are the property of their respective owners | Disclaimer