Desktop PCs Manuals


Part Replacement Instructions
BEFORE YOU BEGIN
Unplug the computer.
Ground yourself.
Note: Before doing any work inside 
your computer, ground yourself by 
touching a metal part of the computer 
frame.
CAUTION: This product contains 
components that are easily damaged 
by Electrostatic Discharge (ESD). To 
reduce the chance of ESD damage, 
work over a non-carpeted floor, use 
a static dissipative work surface (like 
a conductive foam pad), and wear 
an ESD wrist strap that is connected 
to a grounded surface, like the metal 
frame of the PC.
HARD DISK DRIVE (For DVD, see page 2)
Raise the display (monitor) to see release lever (A). 
Holding down the lever (A), pull up the vertical 
cover (B), and remove it from the chassis.
B
A
A
On the hard disk drive cage, loosen the two bottom 
Remove the four screws (G) from the cage, and lift 
screws (C) three turns, remove the two top screws 
the hard disk drive from the cage. Place the new 
(D), lift the cage up off the bottom screws, and then 
hard disk drive into the cage and insert the four 
disconnect the power 
screws.
G
cable (E) and the data 
D
cable (squeeze the 
connector) (F).
E
F
C
G
Connect the power cable (E) and the data cable 
Align and insert the hooks on the vertical cover 
(F), place the hard disk drive cage over the two 
(B) into the holes on the back of the chassis, and 
bottom screws (C) in 
reaching beneath 
the chassis, insert the two 
D
the display, hold down 
top screws (D), and then 
the lever (A) while sliding 
tighten all the screws. 
the vertical cover down 
and into place. Release 
B
E
the lever. 
F
A
C
1


Big size of image:

Please install Flash player from http://get.adobe.com/flashplayer/!

35 35 51 51

Designated trademarks and brands are the property of their respective owners | Disclaimer