598-1172-02 Manuals

ATTAChIng ChIMe CoVeRS
Snap-on Cover: Apply pressure to the cover until it snaps into place (see Figure A). To remove, 
firmly grasp cover and pull to remove from base.
hanging Cover: Before mounting chime base to wall, slide the cover pin that will be on top of 
the mounted base out of the base. Turn it over so the pin is protruding above the base. Slide 
the cover pin into base (see Figure B). Hang cover on cover pin.
Note: Cover pins are located on two sides of the chime base for use with hanging covers. When 
chime base is mounted according to mounting orientation marking, use the cover pin located 
on the top of the chime base for hanging the cover.
Mounted
Cover Pin
Chime Base
 
‘D’
TYPE
LR20
X
-0035-R
TR
 
‘D’
TYPE
LR20
Chime Base
Snap-On 
Cover
Figure B
TR-0095-RX
Figure A
TRouBleShooTIng
Chime does not sound:
TYPE
•  Make sure push b
C
utton and chime codes are the same (See pages 2 and 3).
•  Check orientation of  push button battery (See page 3).
•  Check charge of push button and chime batteries, replace if necessary.
Batteries seem oK, but the chime does not work when installed:
•  Do not mount chime or push button on metal or near metal studs. This reduces the transmitter range. 
Use 1/4" to 1/2" (6 to 13 mm) wood shims to move chime or push button off metal surface.
•  Concrete floors may reduce range. Move chime away from floor.
•  Try locating chime closer to push button.
The range of the wireless chime can vary with location, temperature and battery condition.
-4-
598-1172-02

---

Big size of image:

Please install Flash player from http://get.adobe.com/flashplayer/!