316137234 Manuals


INSTALLATION  INSTRUCTIONS
Over The Range Microwave Oven
BEFORE YOU BEGIN  
          
Read these instructions completely and carefully.
•  IMPORTANT  Save these instructions for local 
•  Proper installation is the responsibility of the installer.
inspector’s use.
•  Product failure due to improper installation is not covered 
•  IMPORTANT  Observe all governing codes and 
under the Warranty.
coordinates.
•  Please read all instructions thoroughly before installing 
•  NOTE TO INSTALLER – Be sure to leave these 
the Over the Range Microwave Oven. Two people are 
instructions with the Consumer. 
recommended to install this product.
•  NOTE TO CONSUMER – Keep these instructions for 
•  If a new electrical outlet is required, its installation should be 
future reference.
completed by a qualifi ed electrician before the Microwave 
Oven  is  installed.  See  3 ELECTRICAL GROUNDING 
•  SKILL LEVEL – Installation of this appliance requires 
INSTRUCTIONS on page 2.
basic mechanical and electrical skills.
1 MOUNTING 
SPACE
2 WALL 
CONSTRUCTION
This Microwave Oven/Hood requires a mounting space on 
This Microwave Oven/Hood should be mounted against and 
a wall as shown in Figure 1. It is designed to be used with 
supported by a fl at vertical wall. The wall must be fl at  for 
standard 12" wall cabinets.
proper installation. If the wall is not fl at, use spacers to fi ll in 
the gaps. Wall construction should be a minimum of 2" x 4" 
wood studding and ³⁄₈" or more thick dry wall or plaster/lath. 
The mounting surfaces must be capable of supporting weight 
of 110 pounds—the oven and contents—AND the weight of 
12"
all items which would normally be stored in the top cabinet 
30"
above the unit.
15.5"
The unit should be attached to a minimum of one 2" x 4" 
wall stud or two 2" x 3" wall studs.

30" or more 
from cooking 
Backsplash
At least 2"
To fi nd the location of the studs, one of the following methods 
surface
may be used:
A.  Use a stud finder, a magnetic device which locates the 
nails in the stud.
B.  Use a hammer to tap lightly across the mounting surface 
to find a solid sound. This will indicate stud location. 
The center of the stud can be located by probing the wall with 
66" or more 
from floor
a small nail to fi nd the edges of the stud and then placing a 
mark halfway between the edges. The center of any adjacent 
studs will normally be 16" or 24" to either side of this mark.
NEED HELP?
For customers in the United States, call: 1-800-944-9044 
Figure 1
For customers in Canada, call: 1-800-213-9397 (English)  
 
 
          1-800-668-4606 ext.8199 (French)
READ CAREFULLY. KEEP THESE INSTRUCTIONS.
P/N 316137234
TINSEB151WRRZ
Printed in Thailand


Big size of image:

Please install Flash player from http://get.adobe.com/flashplayer/!

37 37 52 52

Designated trademarks and brands are the property of their respective owners | Disclaimer